Crown Air Cocking (18+) Colt Python 20mm Rib Mount Rail Flat Type

Crown Air Cocking Gun (18+): 20mm Rib Mount Rail for Colt Python 357 Magnum.
*This is the normal type without a dent on the upper surface. A type with a dent is also listed separately.

It is attached by inserting it into the rib holes and tightening with M1.2-3mm screws (a Phillips precision screwdriver is required). The dimensions are a snug, tight fit. If a scope mount is constantly attached and tightened to this mount rail, the M1.2 screws may not be necessary. (The M1.2 screws will be shipped detached and secured with tape; please be careful not to lose them upon opening.)

It cannot be attached to the foremost rib hole near the muzzle.

The rail can be attached by shifting it approximately 1cm forward or backward within the rib holes.

The image shows an example of it attached to a Colt Python .357 Magnum. The listing is for the mount rail (front and rear, 1 set of 2 pieces) only. The gun itself is not included.

Besides Crown (Air Cocking Gun, 18+), it is rare to have this for older products, but we have confirmed it can be attached to Tanaka's old Colt Python (gas gun, not Pegasus system (photo included)).
It cannot be attached to products from other manufacturers.

This product is made with a 3D printer using PLA material.
Please only bid if you understand that this is a 3D printed product. There may be layer lines, extrusion marks, burrs, stringing, fraying, printing irregularities, fuzziness, etc., characteristic of 3D printing, as well as scuff marks from filing and adjustment.
It may deform in environments above 70°C.

We are not responsible for any injuries or damages caused by this product.

Product specifications are subject to change without notice.

Please, no claims, no returns.